Woody’s® carbide carries innovative features like 60° carbide inserts that are guaranteed not to come out under any conditions, Flat-Top design, rounded wear pads, full-length hardweld and bevel-cut host bar that doesn’t snag trailer edge. Superior quality, construction, performance, safety and reduced expense due to long service life – the Woody’s guarantee.
Flat-Top Runner Design
Woody’s Flat-Top design creates a larger contact area with the ski than a round host bar. The result is greater support, which means less flexing and rocking, with greater steering agility for the driver.
Wear Pad Design
Most Woody’s carbide runners feature carbide wear pads with a rounded surface. The rounded surface is less likely to catch an edge on the trail or on your trailer.
Ultra Series™
Designed for the most aggressive trail riding
5/8" host runner features a full 10" of 60º turning carbide
Carbide wear pads are used throughout the entire bar for longer life
For use with OEM composite ski; track studding required
Sold in pairs
Executive Series™ Flat-Top
Designed for aggressive trail riders and racers
1/2” diameter host runner features a full 8” of 60° sharp edge turning carbide
1 1/2” carbide wear pads front and rear and full-length hardweld surfaces between all three carbide inserts ensure extended wear
Extra-long studs make it easy to install plastic ski skins
Track studding required
Sold in pairs
Trail Blazer IV™ Flat-Top
Designed for aggressive trail riders
Excellent high-speed cornering control
1/2” host runner features 6” of 60° sharp edge turning carbide
Wear pads are a full 1 1/2” long
Full-length hardweld surfaces between all three carbide inserts provide extended wear
Extra-long studs make it easy to install plastic ski skins
Track studding recommended
Sold in pairs
Extender Trail III™ Flat-Top
Woody’s most popular carbide
7/16” host bar carries 4” turning carbide that has a sharp 60° edge angle for performance cornering; 1 1/2” carbide wear pads help extend runner life
Full-length hardweld surfaces between all three carbide inserts for total wear protection
Extra-long studs make it easy to mount plastic ski skins
Sold in pairs
Top-Stock™ Hard Surface Bar
A hardweld runner designed for extreme service or utility applications
1/2" host bar with a double head of hardweld increases the depth of the runner for controllability in grass racing or deep snow conditions
Not recommended to replace OEM carbide runners; not suitable for sleds with over 48 installed studs in track
1/2" thick with flat-top design extended mount studs and a rear angle cut
Sold in pairs
NOTE: Some models require drilling extra holes in ski.
